Page 20
990008 Rev. H
5. Installation and Unit Checkout
After completing the instructions in Chapter 4 you are now ready to install your Kreativ
Mach 5.0 or Mach 5.0 PLUS. Refer to the drawings and descriptions in Chapter 3 for
the identification of the external controls and connections.
Pre-Installation Requirements
•
Adequate Air Supply, Mach 5.0 only. The most convenient set up will be to
integrate the Mach 5.0 into your Dental unit as explained in the previous section. If
you choose to hook up to your in-office air do the following:
1. Ensure that you have at least the minimum air pressure and air flow volume of
clean, dry air (see Chapters 1 and 4 for Air Supply Requirements). Refer to the
Site Preparation information supplied by Kreativ. Ideally, air for the Mach 5.0
will be obtained by placing a "Tee" fitting prior to the final regulator at the
operatory, but after the dryer, traps and various filters.
2. If clean, dry air of adequate pressure and volume is not available, Kreativ
recommends using compressed Nitrogen with a regulator (Follow integration
instructions).
•
Power supply/earth grounding. Note: route the power cord safely out of the way
and do not use an extension cord.
Unit Checkout
•
Set the Power Switch on the back of the instrument to OFF.
•
On the Mach 5.0, connect the end of the air supply hose with the quick disconnect
to the external air supply.
•
Plug the power supply cord into a properly grounded receptacle.
•
Set the Power Switch on the back of the instrument to ON. The Control Module
should now be illuminated.
Chapter
5
Содержание Kreativ Mach 5.0
Страница 13: ...Page 13 990008 Rev H Drawings of Controls Figure 1...
Страница 14: ...Page 14 990008 Rev H Figure 2...
Страница 16: ...Page 16 990008 Rev H...
Страница 35: ...Page 35 990008 Rev H THERE ARE NO HAZARDOUS MATERIALS PRESENT...
