Individual electrical test
The individual electrical test comprises the following three steps:
■
Observation: Visual inspection for damage or improper use
■
Measurement: Carry out prescribed measurements in accordance with accepted engineering standards (protective earth resist-
ance, insulating resistance, protective earth current / leakage current)
■
Testing: Functional test
The individual electrical test must be repeated regularly in accordance with the legal regulations.
Preparing the appliance for first-time use
1.
Bring the ambient temperature to the permitted operating temperature.
2.
Switch on the circuit breaker.
3.
Open the water supply.
4.
Open the gas supply system (applies to gas appliances).
5.
Check that the following are seated properly and in the correct position:
■
Suction panel
■
Racks
6.
Measure the door gap at the front of the appliance, as specified in 'Measuring
If any measured values lie outside the tolerance range, or the top edge of the
appliance door is not flush with the top edge of the appliance case, the appli-
ance door must be adjusted.
Adjust the gap as described in the servicing documentation or contact the
manufacturer.
7.
Switch on the combi oven.
8.
Make the following settings:
■
Date
■
Time
■
Language
Putting the appliance into use
1.
Start the cooking operation using the following cooking data:
■
'Combi-steam' operating mode
■
150 °C
■
10 minutes
2.
Check the following points:
■
Is the oven light illuminated?
■
Is the fan running?
■
Are there any leaks in the water supply and wastewater systems?
■
Does the temperature rise inside the cooking chamber?
3.
Start the cooking operation using the following cooking data:
■
'Steam' operating mode
■
100 °C
■
10 minutes
7 Putting into service
Installation manual
62
