WEICHAI Baudouin PowerKit 12M33 Series, Руководство по эксплуатации и обслуживанию

Страница: 47 / 91

Operation
47
4.2 Starting Up
The following starting/stopping procedure is a simple example (not binding) and it’s based on a
simple starting control panel equipped with starting key. Please refer to the genset and/or
genset control panel use & maintenance manual for the starting operation mode.

Before starting the engine, operate the
stop control lever to ensure flexible
motions, and the crankshaft can rotate
smoothly.

Turn
the key to position “1” to power on
the control panel. The “oil pressure
warning lamp" automatically will turn on
for 10s (Safety line test of ultra-low en-
gine oil pressure). It’s recommended to
test the indicator lamps, bulbs, and but-
tons once (by pressing the touch button
10 on the control panel).
 Turn the key to position “START” to
start the engine and then release the
key. The key will automatically return to
position “1”.
Figure 4.2-Switch
NOTE

At the start of engine, if the engine fails to start within 10s, immediately release the button
and wait for 1min before retry.
 If the engine can’t be started by three consecutive attempts, stop the attempt and find out
and solve the malfunction before retry.
 During the working of engine, the “oil pressure warning lamp” and the "battery power”
indicator lamps are all off.

All indicator lamps are off during normal running of engine.

In event of abnormality, the “horn” will issue warning sound.

The auxiliary starter shall be used to start the engine under cold temperature.

By activate the electric heating flange via relay, the engine can be started success-
fully under low-temperature environment.