WEICHAI Baudouin PowerKit 12M33 Series, Руководство по эксплуатации и обслуживанию

Страница: 16 / 91

Safety
16
1.12 General Precautions for Operation
1.12.1 Before any operation or maintenance on any Baudouin product

Wear personal protective equipment (PPE) where required.
 For maintenance, place a “Do Not Use” or similar sign on the starter switches.

Access to the equipment is only for authorized and qualified personnel.

Ensure that all guards and covers are secured in place on the engine.

Make sure that the repair premises and surrounding area are suitable for safe working.

Inspect the engine for potential hazards. Ensure there are no personnel on, under or
around the engine.

Ensure that the pipes and hoses are not worn or damaged. Pipes must be positioned,
supported and firmly fastened.

Ensure that the electrical wiring is not worn or damaged. Wiring must be positioned,
supported and firmly fastened

Remove all wiring that is obstructive to repair/maintenance or unattached.

Use the proper tools for the operation being performed.

Report all necessary repairs promptly.

Remove any rings, chains and watches before starting work. Wear suitable and
properly-fitting work clothes.

Remove and isolate the control panel key.

Do not perform any operation or maintenance operations which are not fully understood.

Clear the engine of any flammable materials such as fuel, oil or debris.

Do not smoke near the engine or where flammable materials are stored.

Exhaust shields (if equipped) must be fitted correctly.

Do not expose the engine or components to flames.

Do not touch hot parts of an engine in operation or which has just been stopped.

Ensure the starter battery insulation switch is in open position.

Switch off the circuit breaker located in engine connection box (if equipped).

Switch off engine room lock switch or emergency stop (if equipped).

For maintenance, for engines fitted with a pneumatic starter system, isolate the tanks and
evacuate the pipe linking the tanks to the starter.

For engines installed on automatic start genset select the lock position on the selection
mode of the control panel, to avoid the engine start.

Use caution when cover plates or other components are removed. Gradually loosen and
remove bolts/nuts but do not remove the last two bolts which are located on opposite
ends of the plate. Before removing the last two bolts, pry open the plate and gradually
release the pressure.

Do not remove any hydraulic components or parts until the pressure in the system has
been relieved. Contact Baudouin for procedures required to remove hydraulic
components.