Weco WF-104, Инструкция по эксплуатации, Страница: 45 / 96

WELD THE WORLD
Cod. 006.0001.0940
16/04/2018 V.2.25
WF-104
WF-108
45
ENGLISH
A
S2
This button serves to select the following welding mode:
SYNERGIC MIG/MAG
S3
Use this button to select one of the following torch trigger procedures:
2 STROKE
2 STROKE SPOT: The procedure is active when the “SPOT TIME” parameter is set to a value other
than “OFF”.
4 STROKE
4 STROKE B-LEVEL: The procedure is active when the “B-LEVEL” parameter is set to a value other
than “OFF”
3 LEVEL 2 STROKE
3 LEVEL 2 STROKE SPOT: The procedure is active when the “SPOT TIME” parameter is set to a value
other than “OFF”. If the "SPOT TIME" parameter is active in the 3 LEVELS procedure, its value denotes
the time for which the main welding current is supplied.
3 LEVEL 4 STROKE
3 LEVEL 4 STROKE B-LEVEL: The procedure is active when the “B-LEVEL” parameter is set to a value
other than “OFF”
Tab. 7 - Main settings and displays in SYNERGIC MIG/MAG mode
DISPLAY D1 DISPLAY D2 DISPLAY D3
Data setting
Shows the main synergy param -
eter (wire feed rate, Amperes,
recommended thickness), which
can be adjusted with the following
encoder: (E1).
Shows the set welding voltage,
which can be adjusted with the
following encoder: (E2).
Shows the arc correction
executed by the operator with
encoder (E2). Displays D2
and D3 change simultaneous-
ly, but while display D2 shows
the absolute value, display
D3 shows the correction with
respect to the standard and
optimal value proposed by the
manufacturer.
The parameter corrects the
arc dynamics in the POWER
ROOT process.
Welding
Shows the average current meas -
ured during welding.
Shows the average voltage
measured during welding.
Shows the arc correction
executed by the operator.
HOLD function
(At welding end)
Shows the average current
measured during the last welding
procedure performed.
Shows the average voltage
measured during the last weld -
ing procedure performed.
Shows the arc correction
executed by the operator.
10.3.1 Synergic MIG/MAG parameters setting (1st level): synergic curve setting
B
○ Scroll down the list of parameters to be edited by pressing buttons S5 and S6
C
○ Using the encoder E3 , edit the value of the selected parameter
The value is saved automatically.
10.3.2 Manual MIG/MAG parameters setting (2nd level)
D
○ Press the button S7 to enter the 2nd level menu.
B
○ Scroll down the list of parameters to be edited by pressing buttons
S5
and
S6