Weco WF-104, Инструкция по эксплуатации, Страница: 42 / 96

WELD THE WORLD
C
od
. 006.0001.0940
16/04/2018 V.2.25 WF-104
WF-108
42
ENGLISH
10.2 MANUAL MIG/MAG WELDING
Welding is of the Short/Spray type.
Adjustment of the main welding parameters, wire feed rate and voltage is entirely at the discretion of the
operator. The optimal work point must be identified for the required welding type .
During a welding operation with an active JOB, it is possible to temporarily change the parameters
shown in the displays D1 and D2 with their encoders to test the temporary changes made to the weld -
ing operation. At the end of the welding operation (and HOLD is quit) the values of the loaded JOB are
reset.
When the welding operation is not being carried out and a JOB is active through encoder E3, the JOBs
belonging to its sequence can be scrolled.
HOLD
Menu Menu
m/min
mm
S T O P
L1
L2 L3
L4
L5
L6 L7 L8
L9
L10
L11
L12
L13
L14
L15
S1
S2
S3 S4
S5
S6
S7
S8
S9
S10
E1 E2
E3
D1 D2
D4
Example of control panel (applies to model WF-108)
C
SELECTION
SELECTION
SELECTION
D
SETTING
A B A
A
S2
This button serves to select the following welding mode:
MANUAL MIG/MAG
S3
Use this button to select one of the following torch trigger procedures:
2 STROKE
2 STROKE SPOT: The procedure is active when the “SPOT TIME” parameter is set to a value other
than “OFF”.
4 STROKE
Tab. 5 - Main settings and displays in MANUAL MIG/MAG mode
DISPLAY D1 DISPLAY D2 DISPLAY D3
Data setting
Shows the wire feed rate setting
in m/min, which can be altered by
means of the following encoder:
(E1).
Shows the set welding voltage, which
can be adjusted with the following en -
coder: (E2).
Shows “---“.