Weco WF-104, Инструкция по эксплуатации, Страница: 16 / 96

WELD THE WORLD
C
od
. 006.0001.0940
16/04/2018 V.2.25 WF-104
WF-108
16
ENGLISH
CODE SYMBOL DESCRIPTION
E1
Data setting: The encoder adjusts the main welding (and synergy) parameter, shown on the
following display: D1
During welding operations with an active JOB: The encoder temporarily modifies the main
welding parameter, shown on the following display: D1
E2
Manual MIG/MAG mode:
The encoder adjusts the welding voltage, and the relative value is
shown, in volts, on the following display: D2
Synergic MIG/MAG mode: The encoder is used to correct the factory-set value of the selected
synergic curve, the value of which is shown on the following display: D3
During welding operations with an active JOB: The encoder temporarily modifies the main
welding parameter, shown on the following display: D2
E3
The encoder changes the setting of the selected parameter shown on the following display: D4
The selected parameter is shown by the following symbol:

.
Not welding, with a loaded JOB: Scrolling of JOBs belonging to the same sequence.
4 UNIT POWER-UP
Set the welding power source ON/OFF switch to “I” to switch on the unit.
WF 104/WF 108 NOT SELECTED The message will appear on display: D4
The message appears only when the wire feeder is not selected as the remote control on the power
source.