30
30
ANTI-DOUBLE BALL DETENT
SERVICE
ANGEL™ 4
ANTI-DOUBLE BALL DETENT SERVICE
There are two anti-double ball assemblies that can be removed and the internal parts
serviced if necessary. These are located on either side of the body below the feed tube.
· Using a coin, rotate the anti-double ball assembly counter-clockwise to remove the
anti-double case .
· Remove the spring .
· Remove the anti-double ball .
· Repeat for other side.
· Inspect parts and replace if necessary.
IMPORTANT NOTES: For re-assembly of components
· Due care and attention must be shown to ensure you do not mark the
anti-double ball case or ANGEL™ body whilst performing maintenance.
· Ensure the anti-double ball
is re-located correctly.
· Ensure the spring
is located correctly onto the anti-double ball.
· Ensure the anti-double ball cases
are inserted correctly into the
ANGEL™ body.
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
MAINTENANCE –
ANTI-DOUBLE BALL DETENT SERVICE
• Ensure a barrel blocking device is fitted to the ANGEL™
• Ensure the hopper is removed from the ANGEL™
• Ensure that there are no paintballs in the ANGEL™
• Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL™ before disassembly.
• The ANGEL™ can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction to
relieve this residual gas pressure.
m
WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
1 2 3 4 5 6
8 9 10 11 12 13
7
