11
11
FITTING
AN
INTELLIFEED (OPTIONAL
EXTRA)
ANGEL™ 4
FITTING AN INTELLIFEED (OPTIONAL EXTRA)
The ANGEL™ has the ability to trigger motorized loaders with the driving signal coming
directly from the ANGEL™ when used in conjunction with suitable wiring modifications
to your loader.
The ANGEL™ only has the ability to provide a signal and the power source for your loader
still has to be supplied by the loaders batteries.
· Remove the grip cheek cover by removing the 6 retaining screws using a metric
2.5mm A/F Allen key.
· Unplug the battery and solenoid plugs from the PCB.
· Remove the 2 grip frame screws, holding the frame to the body using a suitable
3mm A/F Allen key.
· Remove the grip frame from the body.
· Ensure the SENSI rod is not lost.
· Remove the breech block pull knob by gently pulling and unscrewing counter-
clockwise.
· Remove the countersunk screws holding the back plate in place using a suitable
2.0mm A/F metric Allen key.
· Carefully lift the back plate off.
· Retract breech block lock pin and spring.
· Remove the solenoid cover plate screw.
· Carefully slide the cover plate rearward out of the body.
· Replace the solenoid cover with one that is fitted with the intellifeed socket
ensuring that the solenoid valve is still located correctly.
· Tighten the solenoid valve clamp plate screw using a suitable Allen key.
· Carefully feed the intellifeed wire though the body to exit in the same location as
the battery lead and solenoid lead.
· Plug the intellifeed plug into the PCB into the socket marked ‘HOP’.
· Re-inset all other plugs into the PCB.
· Re-assemble in reverse order.
IMPORTANT NOTES: For re-assembly of components
· Do not pull or apply excessive force to the wires.
· Do not trap any wiring or damage will occur to the wiring resulting in a fault
developing.
· Ensure that the solenoid is located correctly before replacing the cover plate.
· Ensure the cover plate screw is not tightened excessively.
OPERATION
–
FITTING AN INTELLIFEED (OPTIONAL EXTRA)
• Ensure a barrel blocking device is fitted to the ANGEL™
• Ensure the hopper is removed from the ANGEL™
• Ensure that there are no paintballs in the ANGEL™
• Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL™ before disassembly.
• The ANGEL™ can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction to
relieve this residual gas pressure.
m
WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
