23
23
MAINTENANCE
ANGEL™ 4
MAINTENANCE
GENERAL CARE & CLEANING
The ANGEL™should be cleaned externally using a synthetic oil moistened cloth only.
Under no circumstances should you use hydrocarbon based oils, as these
will cause irrevocable damage to the internal seals,
e.g.: WD40, Vaseline, Duck
Oil, Engine oil, Plus Gas, 3in1. The suitable oil is LOVE JUICE OIL™.
The ram shaft and internal parts that are accessible during disassembly and re-
assembly should be lubricated with LOVE JUICE EXTREME GREASE™. The frequency of
lubrication should be at least every event or 8000 shots for oil lubrication and 20,000
shots for grease lubrication. The ANGEL™ should never be immersed into water
otherwise damage may occur to the electronics. The electronics are moisture/damp
proof to IP65. Ensure correct tools are used.
IMPORTANT NOTES: For General Maintenance
· No solvents or abrasive cleaning products should be used. All external and internal
accessible moving parts should be lubricated using light synthetic oil only.
· All threads are metric except gun accessory mountings onto the grip frame,
which is industry standard 10/32 UNF at centres 0.75 inches. The screw thread
length must not exceed 0.375 inches (10mm) into the bottom of the frame
otherwise damage will occur to the electronics. We recommend that you
remove the left-hand cheek cover and ensure the screws do not project into the
circuit board cavity when fitting.
MAINTENANCE –
GENERAL CARE & CLEANING
• Ensure a barrel blocking device is fitted to the ANGEL™
• Ensure the hopper is removed from the ANGEL™
• Ensure that there are no paintballs in the ANGEL™
• Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL™ before disassembly.
• The ANGEL™ can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction to
relieve this residual gas pressure.
m
WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
