![background image](http://html1.mh-extra.com/html/watts/premier-wp4v-50/premier-wp4v-50_installation-operation-and-maintenance-manual_3910972013.webp)
Page 13
Clean filter housings (bowls) with a mild soap solution and rinse with
water. Check O-rings and lubricate with water soluble lubricant.
KY
Jelly
®
or other water based lubricants may be used. Petroleum based
lubricants (such as Vaseline
®
) must not be used.
For more leverage you may leave the RO module attached to wall of
cabinet. If you are unable to access the module while it hangs, remove
it prior to changing filters. Starting with the closest housing
(Stage 1), remove it by turning it clockwise, empty water, then discard
filter. Continue on to the 2
nd
housing (Stage 2).
Insert the new sediment filter (cloth like appearance) into the 1st filter
housing which is the one closest to the side with tubing connections
and re-install housing.
6 Month System Maintenance
Turn off the incoming water supply to the RO at the adapt-a-valve.
(Follow the green tube away from the RO system to find the adapt-
a-valve.)
Step 1
Step 3
Step 4
Step 5
Step 6
Let system sit for a few minutes after tank is empty to depressurize
before attempting to remove filter housings.
Open the RO Faucet and allow water to drain from the tank until it
is completely empty.
Insert the new Carbon Block filter (White End Caps) into the middle
housing and re-install housing.
Step 7
Step 2
Step 8
*Order filters by calling 1-800-752-5582 or buy online at www.premierH2o.com.
√
Stage 1 - Sediment Filter (part #: 104017)
√
Stage 2 - Carbon Block Filter (part #: 101009-White End Caps)
Turn water on to the unit at the adapt-a-valve.
Note:
Water Can be saved in a container for drinking or to rinse
system parts.
Before re-installing the filter bowls back on to the system ,
check O-rings to make sure they are still in place.
Caution:
Open the RO faucet and leave it open until water begins to trickle out
(it will come out slowly).
Step 10
Step 9
Close the RO faucet allowing the storage tank to fill with water.
It
may take 3 to 6 hours to fill the tank completely depending on the
production capability of the membrane, local water temperature and
water pressure.
** To reset the electronic monitor during replacement of filters, slide out the battery from the
base of the faucet, wait one minute and reinsert.
Note:
MAINTENANCE & TROUBLESHOOTING