Watts GTS350C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 20

Page 14
Once all water in the tank is purged, check air pressure using an air pressure gauge, it should
read between 5 - 7 PSI. (Digital air pressure gauge is recommended)
Check Air Pressure in the Tank
Important:
Step 3
Check air pressure only when tank is empty of water!
Step 1 Turn off the incoming water supply to the RO at the adapt-a-valve
(Follow the green tube away from the RO system to find the adapt-
a-valve.)
Open the RO Faucet and allow water to drain from the tank until
it is completely empty.
Step 2
Check air pressure in the storage tank when you notice a decrease in available water from
the RO system. Air can be added with a bicycle pump using the schrader valve that is located
on the lower side of the tank behind the blue plastic cap.
Tip:
When water from the RO faucet slows to a trickle, with the faucet still in the open position add
air to the tank to purge any left over water, this will ensure that the tank is completely empty.
Procedure for Extended Non-Use (More than 2 months)
Turn off the water supply at the adapt-a-valve and open the RO faucet to empty the storage tank
(Save a few ounces of RO water). Once the storage tank is empty, remove the membrane and
place it in a sealed plastic bag with the RO water saved earlier and store in your refrigerator.
For restart, reinstall membrane (See page 13 for membrane installation procedure) and follow
startup procedure on page 10.
Step 4
Follow startup procedure on page 10.