Watts GTS350C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 20

Page 8
Mount the Reverse Osmosis Faucet
Refer to installation instructions found on faucet box.
Drain Saddle Installation
Step 7
Step 8
Step 9 The drain saddle must be installed at least 1 ½” above the nut of the
P-Trap elbow or cross bar from the garbage disposal to insure proper
drainage. Using the 1/4” drill bit, drill into the drain pipe at best available
location as specified above, for drain saddle installation. Take extreme
caution to only drill through one side of the drain pipe.
The small square black foam gasket with a circle cut out of the middle
must be applied to the inside of the drain saddle. Remove sticky tape
backing and stick to the drain saddle. (See Picture to Right)
Locate the correct drain saddle kit in the parts bag.
If you have a garbage disposal, do not install the drain saddle near it. Installation
of the drain saddle must be either above the garbage disposal, or if a second sink
drain is available, install it above the cross bar on the second drain. Installation
of the drain saddle near a garbage disposal may cause the drain line to plug.
Caution:
P-Trap
Elbow
Assemble the drain saddle around the drain pipe and align drain saddle
fitting opening with the hole drilled in the previous step - you may
use a small screwdriver to feed through the drain saddle into the drain
pipe to aid with the alignment. Using a Phillips screw driver tighten the
drain saddle bolts evenly and securely on both sides.
Step 10
1.5”
Caution: Do not over tighten the screws. It may crack the drain saddle.
Red Tube Connection - Drain Saddle
Locate the 1/4” red drain tube that is connected to the membrane
housing. Push the 1/4” red drain tube through the black compression nut
included in the drain saddle kit. Insert the drain tube into the opening
in the drain saddle, hand tighten the black nut and add 1/4 turn with a
wrench. (Refer to diagram on page 5)
Follow all local plumbing codes for your installation.
Step 11
Green Tube Connection - Feed Water
Step 12 Locate the green 1/4” tube and plastic tube insert in the parts bag.
Push the entire plastic insert into green tube. To connect the tube to
the elbow fitting on the sediment pre-filter housing lid, push the 1/4”
green tube through the white compression nut. Hand tighten the nut
to fitting and add 1/4 turn with a wrench. (See Picture to the right)
Insert the other open end of the green 1/4” tube into the open 1/4”
quick connect fitting on the plastic adapt-a-valve making sure the
tube is pushed in all the way passed the o-ring to the tube stop.
(Refer to quick connect instructions on page 7)
Step 13
Compression
Nut
Plastic Tube
Insert
Elbow Fitting
Green Tube
Green Tube
Adapt-a-Valve