Watts GTS350C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 20

Page 9
Blue Tube Connection - RO System
Step 14 Locate a plastic tube insert in the parts bag. Push the entire
plastic insert into the open end of the blue tube attached to the
RO faucet. To connect the blue tube to the Tee fitting attached to
the white tube from the Shut-off Vlave, slip the blue tube through
the white compression nut, hand tighten the white nut to fitting and
add 1/4 turn with a wrench. (Refer to diagram on page 5)
Compression
Nut
Plastic Tube
Insert
Elbow Fitting
Blue Tube
Thread the plastic ball valve onto the tank fitting - ball valve must seal against rubber
O-ring on tank. Do not over tighten or the valve could crack.
Make sure the O-ring is located at the bottom of the recess for the tank connection.
Do not use Teflon tape!
Tank Valve Installation
Step 15
Yellow Tube Connection - RO System
Step 16 Locate the yellow tube and a plastic tube insert in the parts bag.
Push the entire plastic insert into yellow tube. To connect the
yellow tube to the Tee fitting attached to blue and white tubes,
slip the yellow tube through the white compression nut, hand
tighten the white nut and add 1/4 turn with a wrench. (Refer to
diagram on page 5)
Compression
Nut
Plastic Tube
Insert
Tee Fitting
Yellow Tube
Step 17 Position the storage tank in desired location. Measure the
yellow tube from Tee fitting to tank and cut it to desired length.
Locate a plastic tube insert in the parts bag. Push the entire
plastic insert into the yellow tube connected to the RO system in
previous step. To connect the yellow tube to the tank ball valve
fitting installed on the storage tank, slip the yellow tube through
the white compression nut, hand tighten the white nut and add
1/4 turn with a wrench. (Refer to diagram on page 5)
Step 18
Yellow Tube Connection - Storage Tank
Compression
Nut
Plastic Tube
Insert
Ball Valve
Yellow Tube
Reverse Osmosis Module Mounting
Step 19 Determine best location for the RO System to be mounted to allow
for future system maintenance. The parts bag has 2 self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet wall 6” apart and 16” from the bottom of the cabinet.