Page 8
Drain Saddle fits standard 1 ¼” – 1 ½” drain pipes
Drain Saddle Installation
Step 14
Step 15
Step 16
Thread the brass tee (supplied in the parts bag) onto the brass
connection on the top of tank. Tighten using an adjustable wrench.
Step 17
Step 18
Teflon tape must be applied in a clockwise direction. Wrap (7 to 12
turns) around the male pipe threads (MPT) on the Stainless Steel
fitting on top of the tank.
Drill a ¼” hole through the drain pipe at least 1 ½” above the nut of
the P-trap to allow for the removal of the P-trap if necessary.
Assemble the drain saddle around the drain pipe. Position the
drain saddle over the drilled hole in pipe. Insert screw driver into
the opening of the drain saddle and align with drilled hole in drain
pipe. Using Philips screw driver tighten screws evenly and
securely on both sides of the drain saddle. Attach black
compression nut, but do not tighten at this time. The black tubing
will be installed later.
The small square black foam gasket with a circle cut out of the middle
must be applied to the inside of the drain saddle. Remove sticky tape
backing and stick to the drain saddle as shown.
1 Black compression nut
1 Semi-circle bracket with opening
2 Screws
1 Foam washer
2 Nuts for screws
1 Semi-circle bracket
Gather the pieces of the drain saddle
Tank Tee Installation
Caution:
Do not over tighten the screws. It may crack the drain saddle.
Do not teflon tape the compression fitting threads. If taped it will leak.
Caution:
Содержание 5 SV DELUXE
Страница 19: ...Page 19 California Certification...
Страница 24: ...Page 24...
