Watkiss Automation BookMaster, Руководство по обслуживанию

Страница: 81 / 128

Machine Inspections • TrimMaster Standard - Pre-Delivery Inspection
Watkiss BookMaster Service Manual - Issue 1 - 04/12/00
75
5.2 TrimMaster Standard - Pre-Delivery Inspection Notes
These notes complement the test sheet on the previous page.
Section 1 - Visual checks
1. Check all painted surfaces of the machine for blemishes or damage.
2. Check that all guards are fitted:
• 2 side covers
• Front and rear covers
Section 2 - Accessories
1. Check that the TrimMaster has a trim bin installed.
Section 3 - Labels
1. Check that all the required labels are fitted:
• Co / - label
• Conveyor adjustment (inches / millimetres)
• Voltage labels
Section 4 - Pre-run setting up
1. Check all controls and settings:
• Visually check all controls are correctly fitted
• When making adjustments cross-check that the adjustments are prop-
erly calibrated
• Adjust the conveyor through the minimum and maximum travel
making sure it has a free and easy movement
2. Check voltage settings:
Caution
• Before switching on the machine, check that the unit is the correct
voltage
Section 5 - Running checks
1. Hand-feed 2, 4, 8, 16 and 20 sheets of A4 into the BookMaster and check
that all the booklets are cut squarely and cleanly (pay particular attention
to the first sheet cut, look for a ragged edge).
Section 6 - Safety switches
1. Check the machine stops if the trim lid is opened.
Section 7 - Pre-delivery checks
1. Check that the machine is clean.
2. Record the serial no. of the machine.