You can edit detector parameters when the system is idle by clicking the underlined value. You
cannot edit these values while the system is running samples.
Figure 3–8: TUV detector control panel
Lamp LED – Mirrors the lamp status LED on the front panel of the detector, unless
communications with the detector are interrupted.
Lamp ignition – When clicked, ignites or extinguishes the lamp. If the icon is green, the lamp
is ignited. If the icon is red, the lamp is extinguished.
Value of wavelength A – Displays the value of wavelength A, in nm. If the detector is in dual
wavelength mode, the value of wavelength B also appears.
AU – Displays the absorbance units of wavelength A. If the detector is in dual wavelength
mode, the absorbance units of wavelength B also appears.
Status – Displays the status of the current operation.
You can access these additional functions by right-clicking anywhere in the detector control
panel.
Table 3–11: Additional functions in the TUV detector control panel
Control panel function
Description
Autozero
Resets the absorbance value to 0.
Reset module
Resets the detector after an error condition.
Help
Displays console online Help.
3.5.9 2432 conductivity control panel
The 2432 conductivity detector's control panel displays the conductivity, peak polarity, and the
cell temperature.
August 8, 2016, 715005049 Rev. C
Page 59
