Waters ACQUITY CM-30S, Обзор и руководство по обслуживанию, Страница: 23 / 146

October 7, 2014, 715004178 Rev. B 23
2
Preparing and operating the
CM-30S
Contents:
Topic Page
Securing the CM-30S to the system stack ...................................... 24
Installing the leak sensor ................................................................ 32
Installing the waste tubing ............................................................. 34
Connecting to the electricity source ................................................ 38
Monitoring LEDs.............................................................................. 38
CM-30S control panel ...................................................................... 39
Installation recommendations for fittings ...................................... 41
Assembling new fittings .................................................................. 43
Installing dual-threaded, finger-tight fittings................................ 44
Installing or replacing a column plate in the column
compartment .............................................................................. 45
Installing and removing a single column on the column plate...... 54
Connecting an external valve.......................................................... 65
Warning:
To avoid explosion, do not use the CM-30S with solvents
whose autoignition temperatures are below 150
°
C.
Warning:
To avoid breathing harmful fumes or vapors, when using
hazardous solvents, run the system in a hooded environment that
provides a sufficient air exchange rate.
Warning:
To prevent burn injuries, allow sufficient time for the CM-30S
to cool before opening the device’s door. The heater compartment,
columns, column plate, preheater assembly, tubing, fittings, and door
liner can be extremely hot.