WaterLogic escowa Purus iQ3, Руководство по обслуживанию

Страница: 17 / 36

5. Sanitation and cleaning.
5.1 Sanitation with Anolyte- sani - Brita Service cartridge.
5.1.1 Sanitation with the Service Cartridge.
Sanitation should be carried out at installation and at 6 monthly intervals.
1
2
3
1. Turn off Water Supply. Press the button for ambient water for
3
10 sec, then press the button for Cool water for 10 sec. Now
press the sparkling water button, keep pressed until the
water stops and only CO
2
gas is dispensed. Close the CO
2
regula- tor valve, press the Sparkling water button again to
release the gas pressure. Now switch equipment power
supply off.
2. Lead the grey hose of the filter head into a container and
press the grey button on the filter head to release the
pres- sure in filter.
3. Place the cleaning agent in the special service cartridge.
4. Remove the filter Brita C1000 cartridge. and replace with the
Service Cartridge.
4
5. Place a container under the discharge. Press the key still
chilled water button until the water turns blue in colour.
Press ambient water button, until the water turns blue in
colour,
use a indikator to check. Press the button for sparkling water
briefly so the pump starts, wait for the pump to stop
(carbona- tor full), press and hold the sparkling water button
until water turns blue in Colour.
6. Wait for 20 mins. so that the solution can activate.
5
7. Remove the service cartridge and refit the Purity1000 filter
(if necessary renew the filter if Service life or capacity
is reached).
8. Rinse water through each button chilled, ambient and
spar- kling until water runs clear through each selection.
Examine the pH value (acidity). Still= 6.5 - 7.0, Sparkling =
6 - 6.5
9. Open the CO
2
regulator valve and dispense 2 L
sparkling water to re-carbonate.
10. Fill out the service record.
17