WarmFlow A Series, Инструкция пользователя

Страница: 34 / 89

Page 32
Ref. Text Description Expected Value(s)
T32
Max Frequency
Allowed for
Driver This is the maximum allowed speed of the
compressor. 120Hz
T33
IPM Shutdown
Protection
Temp. This is the temperature on board the IPM
module aboe which the unit will shut down.
Calculated value based on current
conditions.
T34
AC Input
Voltage This is the current incoming AC voltage
measurement. Typically between 210Vac and 240Vac.
T35
AC Input Current This is the current incoming AC current
measurement.
Typically between 1Amp and 33Amps.
T36 Phase Current
of Compressor This is the compressor current measurement. Typically between 1Amp and 33Amps.
T37 DC Bus Voltage This is the current voltage measurement for
the communication bus. Up to 5V.
T38 IPM Temp.
This is the temperature on board the IPM
module. Ambient temperature if the appliance
has been off for a time.
T39 Water Flow This is the flow rate of water through the unit
from the system. This should read 0.0m 3 /hr when the unit
is off and between 0.3 m 3 /hr and 5.0
m
3
/hr when the unit is running.
This appliance must be serviced annually or as indicated by the user interface
controller. Contact Warmflow for further details.
In the event of a breakdown please refer to section 3.14 - Alarms and Troubleshooting.
Alternatively, contact your commissioning engineer who should then contact our service
department whilst at your home, to report the fault.