56
Lexa PLUS | Instructions for Use | RIS-311 ENG Rev03 | 29/08/2022 | © W&H Sterilization Srl
Sterilization cycles
1
On the homepage, tap the cycle and
.
2
Tap the leaf icon to set the ECO DRY mode.
3
Tap the ECO DRY mode you desire.
4
Tap to confirm and go back to the previous page.
5
To change the start time, tap
Start cycle at
.
6
Tap the time or the date: a settings page opens.
7
Tap the number you want to change and tap
or
to
increase it or decrease it.
8
Tap
to confirm and go back to the previous page. This date
and time become the scheduled default start time for all next
sterilization cycles.
9
Tap
to lock the door and start the countdown for the
current cycle.
Note
: You can decide to start the cycle immediately or stop the
countdown at any time.
PROGRAM A SEQUENCE OF CYCLES TO RUN AUTOMATICALLY
It is possible to program the sterilizer in such a way that a sequence
of cycles runs automatically at a preset date and time (e.g. if you
want to run a vacuum test in the early morning before office hours).
Maximum two cycles can be programmed.
To program the sterilizer proceed as follows:
1
Load the chamber and close the chamber door.
2
On the homepage, tap
>
>
>
3
Tap to add a cycle to the list above.
4
Tap
and then the cycle you want to add.
5
Tap
: the cycle is automatically listed in the previous page.
6
Tap the date/time to set the start of the cycle.
7
Tap the number you want to change and tap
or
to
increase it or decrease it.
8
Tap to confirm and go back to the previous page.
9
Repeat steps from 3 to 7 to add another cycle to the
sequence.
10
Tap
to launch the programmed sequence.
DELETE A CYCLE FROM A PROGRAMMED SEQUENCE
1
On the homepage, tap
>
>
>
2
Tap the cycle you want to remove from the sequence.
3
Tap to remove the selected cycle.
4
Tap to confirm and go back to the previous page.
