Wallenstein WP845, Руководство оператора

Страница: 46 / 72

6.14.2 Start the Chain Saw
1. Open the holder draw latch.
2. Slide the chain saw out of the holder.
3. Start the chain saw.
For instructions, see the chain saw manufacturer's manual.
4. Carefully, slide the adapter into the holder guides.
01138
Fig. 36 –
Slide the adapter into the holder
5. Close the draw latch over the adapter catch to secure the
chain saw to the holder.
01139
Fig. 37 –
Holder draw latch
6.14.3 Cut a Log
1. Make sure the log-length guide is set to the desired cut
length and the end of the log is touching it. For instructions,
see
Set the Log-length Guide on page 37 .
2. If required, start the chain saw. For instructions, see Start
the Chain Saw .
3. Operate the saw as you normally would to cut a log. You
can also use the holder pivot handle. The guard rests on
top of the log, while the chain saw cuts through it.
4. Decrease the cutting pressure as you finish the cut. The cut
log falls into the splitter.
5. Rotate the chain saw back to the idle position.
01153
Fig. 38 –
Cut a log
Operating Instructions
WP845 / WP875
Trailer Firewood Processor
46