Wallenstein WP845, Руководство оператора

Страница: 30 / 72

6.4.6 Add Oil to the Engine
IMPORTANT! For more information about engine oil, see
the engine manufacturer's manual and
Engine Oil on page
57 .
The engine has three oil-fill locations. The two most accessible
locations are shown in the following image. The third location is
on the opposite side of the engine, below the dipstick.
1. Check the engine oil level to make sure that the oil level is
low. For instructions, see
Check the Engine Oil Level on
page 29 .
2. Turn an oil-fill cap counterclockwise to remove it.
3. Use a clean funnel to slowly add the correct type and
amount of oil.
Do not overfill.
4. Wait a minimum of one minute.
5. Remove the funnel, and then check the engine oil level.
6. Install and secure the oil-fill cap to prevent spillage.
01779
Fig. 18 –
Engine oil-fill locations
6.5 Hydraulic System Operation
A hydraulic system is a closed-loop system that uses
pressurized fluid to provide power to devices (for example; the
winch motor and the push block cylinder).
6.5.1 Hydraulic System Safety
• Make sure that all hydraulic system components are kept
clean and in good condition.
• Relieve pressure on the hydraulic system before working
with it. The hydraulic system operates under extremely high
pressure.
• Before applying pressure to the hydraulic system, make
sure that all the connections are tight, and the hoses and
fittings are not damaged.
• Immediately replace any hydraulic hose that shows signs
of swelling, wear, leaks, or damage. A swollen, worn,
damaged, or leaking hose can burst and cause a hazardous
and unsafe condition.
• High-pressure hydraulic oil leaks:
-
Do not use your hand to check
for hydraulic oil leaks. Hydraulic
fluid escaping under pressure can
penetrate the skin causing serious
injury or death. Use a piece of
cardboard or wood to check for
leaks.
-
Wear the correct hand and eye
protection when searching for a
high-pressure hydraulic leak.
-
Seek medical attention immediately if injured by a
concentrated high-pressure stream of hydraulic fluid.
Serious infection or toxic reaction can develop after
hydraulic fluid pierces the skin's surface.
• Do not attempt any makeshift repairs to the hydraulic lines,
fittings, or hoses. Do not use tape, clamps, or cements to
attempt a repair. Doing so can cause sudden failure and
create a hazardous and unsafe condition.
• Do not bend or strike high-pressure lines, tubes, or hoses,
or reinstall them in a bent or damaged condition.
• Make sure that hydraulic hoses are routed to avoid chafing.
• Never adjust a pressure relief valve or other pressure-
limiting device to a higher pressure than specified.
Operating Instructions
WP845 / WP875
Trailer Firewood Processor
30