Wallenstein WP845, Руководство оператора

Страница: 36 / 72

6.10.2 Unfold the Splitter Chute
1. Remove the linchpin from the tab on the LH side of the exit
chute.
2. Remove the hitch pin from the splitting-cradle bracket.
Remove the linchpin, and then slide it out.
3. Carefully unfold the splitter chute. Make sure the square
tube on the bottom of the splitter chute goes between the
bracket on the end of the splitting cradle.
4. Insert the hitch pin through the splitting-cradle bracket and
splitting chute. Insert the linchpin through the hitch pin.
5. Insert the linchpin from Step 1 through the tab you removed
it from for safekeeping.
01834
Fig. 22 –
Unfold the splitter chute
6.10.3 Set the Splitter Chute Height
The maximum height the front end of the splitter chute can be
set to is 54" (1.37 m).
1. Slightly lift the splitter chute to take the load off the
adjustment bracket.
2. Remove the linchpin from the hitch pin.
3. Pull the hitch pin out of the splitter chute.
4. Raise or lower the splitter chute to the required height.
Line up the hitch pin holes.
5. Insert the hitch pin through the holes.
6. Insert the linchpin through the hitch pin to secure it.
01229
Fig. 23 –
Set the splitter chute height
Operating Instructions
WP845 / WP875
Trailer Firewood Processor
36