wallas Spartan, Руководство пользователя

Страница: 30 / 39

- 29 -
Software update
Software updates are recommend to check and do annually to ensure optimal heater performance.
Before software update:
- check that unit and cell phone have sufficient level of power in battery
- check the WiFi and internet connection
- be prepared to disconnect control panel cable, or heater power to make master reset to the system.
SW update is a complicated process, and something may happen during the update, example :sudden network failure,
which can effect to you boat heating.
Therefore it is forbidden to start SW update for control panel if the Wallas heater is the only heat source and being
unable to start heater would create a danger.
For SW update make
sure you have strong and
reliable wifi signal.
Wifi HotSpot name
(SSID) is visible in
application page and
status is "Connected".
It is advised to turn the
heater "OFF" before
starting the update.
Update may take up to 6
minutes, depending on
network and connection.
If new SW version is
available "Update link"
will appear into display.
Select uppdate.
Do not close application
or heater power while
update in ongoing.
Control panel display will
close and start a few
times during the update.
After the update is done,
control panel will start
and application will
reconnect to panel. Note
in some phone model
you may have to re-
bonding after SW update
again.
Wait 5 minutes update to
finish.
If update is not
succesfull, file error:
- start update again after
few minutes
If update is stopped
during download
( % count is no 100%)
-close application
-restart you device BT.
- start update again.
if update is not able to
finish:
- find different place,
where wifi signal is better
or wifi hotspot has better
connection.
If control panel is jammed
during update ,
disconnect panel cable
and try again after few
minutes.