8.
Connect to power supply
6.
Switch off device.
See
Switch on and off of device
.
7.
Compare the local power supply with the connected load of the device.
If the values differ, please contact [email protected] or tel. +49 843294890.
8.
Connect the power cord with the socket on the device and with the power
socket.
9.
Switch the device on and off
12.
When the protection cap is mounted:
Demount protection cap.
See
Demount and mount protection cap.
WARNING!
Danger of fire through heat accumulation. Never use the
device with mounted protection cap.
13.
Switch on device:
Set main switch on I (ON).
The digital display OUTPUT POWER shows the current adjusted flash
output.
The LED TEST lights up, when the adjusted flash output is reached.
ADVICE: An integrated soft-start prevents the flash tube from damage. It
will take 1-2 seconds until the flash output is reached.
The modeling lamp lights up, if it was switched on, when the device was
switched off.
The LED AUDIO lights up, if the acoustic beeper button was switched on,
when the device was switched off.
LEDs of SLAVE function light up, if photo cell or pre-flash suppression
were switched on, when the device was switched off.
14.
Switch off device:
Set main switch on O (OFF).
All signals will go out.
When the modeling light was switched on:
The modeling lamp will go out.
ADVICE: A special discharging electronics release the residual voltage after
switching off. You cannot stop this safety function.
10.
Adjustments
10.1.
Adjust flash output
You can regulate the power of the flashes according to the below-mentioned
chart.
Flash output
Check value
F-stops
6,0
1 (full power)
5,0
3/4
4,0
1/2
3,0
1/4
2,0
1/8
1,0
1/16
16
16
13
14
