WARNING
Danger of crashing, entrapment, burning and fire through the falling down of
the device.
The weight of the flash is, depending on the model (VC-200 to VC-1000), up to
3,3kg. The modeling lamp, flash tube and reflector could heat up up to 240°C.
Make sure, that the device is always positioned tilt and skid resistant and
stored securely.
Keep out of reach of children and animal. They could overturn the device.
Avoid placing cables where they can be tripped over. The device could be
overturned.
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even if
it is switched off. Just after disconnecting the device from the power supply
through pulling out the power cable, the device is actually de-energized.
Switch off your device when it is not in use.
Switch off your device before mounting and maintenance and disconnect
from power supply.
Protect your device against unintended switching-on.
Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity
or moisture. A short-circuit can warm up the conductors, so that there
isolation will melt or even melt thoroughly. This could lead to fire.
Please just use the original cables, which are included in delivery. They are
aligned for your device and guarantee the necessary safety for you and
your device.
Don´t operate the device with wet hand or feet.
Operate the device only in dry rooms.
Don´t operate the device outdoors.
Please only follow this instruction manual for cleaning your device.
Make sure, that cables and conductors won´t be damaged. Damages could
be caused through heat impact, chemical influence or through mechanical
impacts as rubbing, bending, tearing, rolling over or nibbling animals.
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before
switching on again.
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord. Never
operate your device with damaged housing, damaged reflector, defect
modeling lamp, defect flash tube or damaged power cord. Don´t open the
device. Never repair the device on your own. The device should only be
repaired by electricians.
Please follow this instruction manual for maintaining your device.
Please just use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
WARNING
Fire danger through overheating
The device can overheat, if you operate it with mounted protection cap or
with covered ventilation slots. The device itself or easily inflammable
materials in close distance could catch fire.
Don´t operate the device with mounted protection cap.
Don´t cover the ventilation slots of the device during operation.
Remove easily inflammable materials.
Please just use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
WARNING
Fire danger through hot parts
The modeling lamp and flash tube could heat up up to 240°C, the reflector up
to 75°C and the flash housing up to 45°C. Easily inflammable materials could
catch fire, if they get in contact with hot parts.
6
