Waldorf Q Rack, Руководство пользователя

Страница: 44 / 174

Multi Mode – Instrument settings
Waldorf Q User’s Manual 44
LowKey |HighKey 1
C-2 | G8
LowKey
C-2…G8
Equivalent to the velocity switching parameters, you can restrict the key range used for the
instrument’s tone generation. Only notes with a key number higher or equal to the selected value are
passed through. Set this parameter to
C-2 if you want to use the full keyboard range.
HighKey
C-2…G8
HighKey is the counterpart to the LowKey parameter. Only notes with a key number lower or equal
to the selected value are passed through. Set this parameter to G8 if you want to use the full keyboard
range.
Pattern
off, 001…100
Each Instrument can point to one Sequencer Pattern in memory. The Pattern is played back as soon as
you hit
Start/Stop .
☞
To select a Sequencer Pattern for an Instrument:
• Use the
right display dial
to select the Sequencer Pattern 001…100 .
Pattern #001 1
Bigbeats AJH
☞
To switch the Sequencer Pattern off:
• Turn the right display dial all the way to the left until the display reads:
Seq. Pattern Off 1

When you set up several Instruments to use different Sequencer Patterns, you can build up
complex multi track patterns that i.e. play back a whole rhythm section. In combination with
the
LowKey
and
HiKey
parameters you can even set up zones of the keyboard to transpose
these Sequencer Patterns while other zones can be played as usual.
Ctrl W…Ctrl Z
0…120
Ctrl W |Ctrl X 1
002 (02) |004 (04)
Ctrl Y |Ctrl Z 1
011 (0B) !012 (0C)
These parameters are used to define arbitrary MIDI Continuous Controllers as modulation sources for
the Sounds in the active Multi. You can set up four Controls, W, X, Y and Z, for this purpose. Each
value represents a MIDI Continuous Controller number that is used when you assign its parameter as
modulation source in the Modifiers or the Modulation Matrix. The highest possible Controller number
is
120 because all higher numbers are reserved for non-real-time purposes. If global is selected, the
corresponding settings for
Ctrl W...Z
made in the global parameter section are used.