Waldorf Q Rack, Руководство пользователя

Страница: 126 / 174

Sound Parameters – Envelopes
Waldorf Q User’s Manual 126
Loop S1S2
The Loop S1S2 envelope type loops the envelope between Sustain 1 and Sustain 2 as long as a note is
held, after it went through the attack phase once. This means, when Sustain 2 is reached, Decay 1 is
used to go to Sustain 1 again, then Decay 2 is used to go to Sustain 2 and so on. As soon as the note
is released, the envelope proceeds with the Release phase. It uses the parameter set of the ADS1DS2R
envelope.
Attack Decay
Sustain
Release
Key pressed Key released
Time
Level
100%
Attack Level
Sustain 2
Decay 2
Loop
Picture 42: Loop S1S2 Envelope
Attack 0…127
Determines the attack rate or amount of time it takes for a signal to go from zero to Attack level.
Attack Level
0…127
Controls the level where the
Attack
phase ends and the
Decay
phase starts.
Decay 0…127
Determines the d ecay rate or amount of time it takes for a signal to reach the Sustain level. This
phase is also used in the loop to go from
Sustain 2
to
Sustain
.
Sustain
0…127
As soon as the Sustain level is reached, the envelope proceeds with the second Decay/Sustain pair
as explained below.
Decay 2 0…127
Determines the decay rate or amount of time it takes for a signal to reach the
Sustain 2
level.
Sustain 2
0…127
Sets the second Sustain level. As soon as this level is reached, the loop starts by using the first Decay
rate to go to the first Sustain level.
Release
0…127
Once the note is released, the release phase begins. During this phase, the envelope fades to zero at
the rate determined by the Release value.