The System Menus
68
M Manual
r
When MIDI Clock Send is enabled while the M’s DIN
or USB MIDI In and Out are connected to your se-
quencer, you will probably get a MIDI loop. A total
hangup of your system may result. Ensure to disable
the M’s MIDI clock sending feature in such a case.
Arpeggio Notes Out
Here you can determine, where all notes generated by the
Arpeggiator is being sent out. If
off
ist selected, no arp note
data is send out.
DIN
means via DIN MIDI only,
USB
means
via USB MIDI only and
DIN+USB
means on both MIDI ports.
Velocity Curve
Determines the overall dynamic response curve of the
incoming MIDI velocity for the Sound programs. By selec-
ting one of the 10 curves, the dynamic velocity will adapt
on that.
r
You can find some diagrams of the available velocity
curves in the Appendix of this manual.
CC Controller A...D & W...Z
These parameters are used to define modulation sources
that are freely definable MIDI controllers. Each value re-
presents a MIDI controller number that is used when you
assign its parameter as modulation source.
g
Example: You want to control the LFO1 speed via
MIDI controller #102. To do so, set
CC Controller
A
to
102
first. Then, navigate to the LFO1>Mod dis-
play page and select
Ctr A
as
RTEMODS
(Rate mo-
dulation source ) and finally apply an suitable
RTEMODA
amount. In the same way you can the
other
Controller B..D
and
W...Z
for further as-
signments.
Содержание M
Страница 1: ...User Manual ...
