WAGNER HT4500, Руководство по эксплуатации

Страница: 12 / 96

INFORMATION ON THE DISPOSAL OF WASTE ELECTRICAL & ELECTRONIC
EQUIPMENT KNOWN AS WEEE
Your attention is brought to new directives applicable to the disposal of this electrical
equipment, where in accordance with legislation this product must not be disposed of in
your normal household waste. Instead it is your responsibility to dispose of this type of waste
by handing it over to special designated collection points for recovery and recycling. This
product is marked with a ‘Wheelie bin’ symbol with a cross on it to remind you of this action.
The objective of this directive is to help conserve resources and ensure that it is recycled
in a manner that protects human health and the environment. For more information about
where you can drop off your waste please contact your local authority. Take back facilities
are free of charge.
MIN SIZE 5mm WIDE X 7mm HIGH
MAINS CONNECTION (UK Only)
This unit is a Class II appliance which means it is double-insulated for your protection. No earthing wire is
necessary.
If the power cord is damaged, it must be replaced by Wagner or its appointed agents to avoid a safety
hazard.
Please read the following safety instructions before use:-
1. If the plug is cut off from the power cord then the plug must be disposed of safely.
NEVER under any circumstances insert such a plug into a 13 Amp socket-outlet.
2. A replacement fuse must be rated at 13 Amp and manufactured and approved to BS 1362.
3. IF IN ANY DOUBT CONTACT A QUALIFIED ELECTRICIAN.
If you need to fit a plug to the power cord, this should be fitted in accordance with the wiring instructions
below and will need to be used with a 13 Amp fuse. If in doubt consult a qualified electrician.
If you are using an extension lead it must be rated a minimum of 10 Amps and fully unwound. Do not
operate with a lead rated less than 10 Amps as this will cause premature component failure which is not
covered by the guarantee.
As the colours of the wires in the power cord of the appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
12
EN