Wacker Neuson GPi 1700, Руководство оператора

Страница: 28 / 52

Operation GPi 1700
wc_tx001234gb.fm
28
2.13 Starting the Generator
Starting
procedure Follow the procedure below to start the machine.
1. Turn the engine switch (y) to the CHOKE position (or the RUN position if the
engine is warm or the ambient temperature is high).
2. Pull the recoil starter (a) slowly until you feel resistance.
3. After you feel resistance, return the recoil starter to its original position and pull
quickly. The engine will start.
4. If you started the machine with the engine switch in the CHOKE position, allow
the engine to run for 20–30 seconds and then turn the engine switch to the RUN
position.
5. Check to make sure that the pilot indicator light (p) is illuminated. This indicates
that the generator is operating properly.
Troubleshooting If the engine does not start after several attempts, repeat the starting procedure
with the engine switch turned to the RUN position. If the engine still does not start,
refer to the
Troubleshooting chapter in this Manual.
CAUTION
Personal injury or machine damage hazards. Starting the generator with equipment
attached can damage the generator or the equipment. Unexpected equipment
start-up can cause personal injury.
f
Disconnect all equpment from the generator before starting it.
wc_gr006656
a
p
y