Wacker Neuson GPi 1700, Руководство оператора

Страница: 10 / 52

Safety Information GPi 1700
wc_si000347gb.fm
10
„
Make sure the machine is on a firm, level surface and will not tip, roll, slide, or
fall while operating.
„
Remove all tools, cords, and other loose items from the generator before
starting it.
Electrical
safety To increase electrical safety while operating this machine:
„
Do not operate the generator, or tools attached to the generator, with wet hands.
„
Do not use worn electrical cords. Severe electrical shock and equipment
damage may result.
„
Do not operate generator in standing water.
„
Make certain the machine is well-grounded and securely fastened to a good
earthen ground per national and local regulations.
„
Do not overload the generator. The total amperage of the tools and equipment
attached to the generator must not exceed the load rating of the generator.
.
Generator
vibration Generators vibrate in normal use. During and after the use of the generator, inspect
the generator as well as extension cords and power supply cords connected to it
for damage from vibration.
„
Have damaged items repaired or replaced as necessary.
„
Do not use plugs or or cords that show signs of damage such as broken or
cracked insulation or damaged blades.
Operating
safety To increase operating safety while running this machine:
„
Do not operate the generator when open containers of fuel, paint, or other
flammable liquids are in the vicinity of the generator.
„
Do not place flammable material or liquids near the generator.
„
Do not operate the machine indoors.
„
Do not touch the hot engine, exhaust, or generator components. Burns will
result.
Always do the following:
„
Wear hearing protection when operating equipment.
„
Keep the machine at least one meter (three feet) away from structures,
buildings, and other equipment during use.
„
Keep the area immediately surrounding and underneath the machine clean,
neat, and free of debris and combustible materials. Make sure that the area
WARNING
Backfeed from the generator into the public power distribution system can seriously
injure or kill utility workers!
f
Improper connection of generator to a building’s electrical system can allow
electrical current from the generator to backfeed into utility lines. This may result
in electrocution of utility workers, fire, or explosion.
f
Connections to a building’s electrical system must be made by a qualified elec-
trician and comply with all applicable laws and electrical codes.
f
If connected to a building’s electrical system, the generator must meet the
power, voltage, and frequency requirements of the equipment in the building.