Wachs FF 424, Руководство пользователя, Страница: 33 / 70

FF 424 FLANGE FACING SYSTEM
SECTION V FF 424 SET UP AND OPERATING PROCEDURES
NOTE: Machine rotates clockwise as
viewed from the rear of the machine.
Cutting bit must face clockwise.
(Figure 9)
11. Install the flange facing machine on the
mandrel shaft. Be sure to wipe the mandrel
clean.
NOTE: Align the internal machine keys with the
mandrel keyway slots.
Engage the internal machine keys on the mandrel
keyway slots. Push the machine forward. Rotate the
handle assembly clockwise, engaging the machine
feed nut into the threaded portion of the mandrel
shaft. (Figure 10)
(Figure 10)
12. Install the tooling onto the flange facer tool
slide slot. Refer to the tool holder/tool bit
diagram. (Figure 11)
(Figure 11)
13. Tighten the tool bit locking set screws with
the supplied hex key set. (Figure 12)
14. Attach the air supply. Press the air motor
lever and rotate the machine slowly, to verify
clearance. (Figure 13)
IMPORTANT:
E.H. Wachs Co. recommends the use of an
ATM air treatment module(P.N.-26-407-00)
to filter air and lubricate the air motor. The
air motor warranty will be void if an ATM is
not used.
(Figure 12)
11.
31