Wachs FF 424, Руководство пользователя, Страница: 32 / 70

FF 424 FLANGE FACING SYSTEM
6. Insert the leg set into the adapter. (Figure 5)
SECTION V FF 424 SET UP AND OPERATING PROCEDURES
7. Place the mandrel assembly into the flange
I. D. with one leg at the 6 o’clock position.
The legs should be kept as close as possible
to the flange l.D. edge, yet back far enough to
perform the desired operation. Snug the man
drel into place by tightening the draw bar nut
(Figure 6) with the supplied 1-1/8” wrench
NOTE: Observe the mandrel keyway slots. When
the slots are at the nine o’clock and three o’clock
position the flange facer motor position can be
placed at the six o’clock or twelve o’clock location.
Position the mandrel slots at the desired location
for air motor clearance or operation.
(Figure 5)
8. Slide the flange alignment fixture over the
mandrel shaft. (Figure 7)
9. Extend the alignment arms, if necessary, with
the supplied hex key set. (Figure 8)
(Figure 7)
10. Loosen the mandrel assembly using the
draw bar nut and push the alignment fixture
firmly against the flange face. Retighten the
draw bar nut with the supplied 1-1/8” wrench.
(Figure 9)
(Figure 8)
(Figure 6)
10.
30