VRmagic Eyesi Slit Lamp, Инструкция по установке и эксплуатации, Страница: 36 / 64

Fig. 28: Align red dots
2. Lead the remaining cables through the duct above the simulator PC (
Â
Fig. 27
on page 35).
3.
At the back of the simulator PC, connect the USB plug to a free USB port
(
Â
Fig. 23 on page 32, #6).
4. Connect the VRx plug to one of the VRx connectors of the simulator PC
(
Â
Fig. 23 on page 32, #1). Make sure the red dots are aligned (
Â
Fig. 28 on
page 36).
5. Connect the DisplayPort plug to the DisplayPort connector of the simulator PC
(
Â
Fig. 23 on page 32, #3). Make sure you use the slit lamp DisplayPort (not
the one for external monitors).
Connecting the cable coming from the top of the slit lamp:
A cable with a USB plug runs from the top of the slit lamp along the cable holder
towards the simulator PC (
Â
Fig. 18 on page 28).
1. Connect the USB plug to a free USB port of the simulator PC (
Â
Fig. 23 on
page 32, #6).
4.3.4 Sensor Box
The sensor box is located underneath the table, directly above the simulator PC.
You already connected the light control panel to the sensor box (
Â
section 4.2.7 on
page 29). Now you will connect the three cables on the other side of the sensor
box (
Â
Fig. 29 on page 37).
Eyesi Slit Lamp Simulator – Installation and Operating Guide
36
Installation