VorTek SonoPro S34 Series, Инструкция по эксплуатации

Страница: 23 / 83

Series S34 Instruction Manual Chapter 2 Installation
M-000-00030 2-12
Wiring Connections
Input Power Connections
Connect the AC power adapter to 100-240 VAC, 50 to 60 Hz, to charge the
internal lithium batteries.
Figure 2-12. AC Power Adapter
Transducer Connections
Connect the transducer cables to the transducers and the SonoPro
®
handheld
unit. The cable marked with blue heat shrink wrap is intended for the down-
stream transducer and connector on the handheld unit labeled “DN”. The ca-
ble marked with red heat shrink wrap is intended for the upstream transducer
and connector on the handheld unit labeled “UP”. Cables are interchangeable
but are marked for convenience. Note: there is a key on the male connector
found on the transducer and a keyway on the female connector found on the
top of the handheld unit. The key on the male end of the connector must be
placed in the keyway of the female end of the connector to allow for proper
alignment of the connectors.
Figure 2-13. Transducer Connection Points
Warning!
To avoid potential electric
shock, follow National Electric
Code safety practices or your
local code when wiring this
unit to a power source and to
peripheral devices. Failure to
do so could result in injury or
death. All wiring procedures
must be performed with the
power off.
Use a Class I or Class II
power supply.
Only the connectors supplied
with the meter are to be used
for connecting wiring.
If the equipment is used in a
manner not specified the pro-
tection provided by the equip-
ment may be impaired.