VorTek SonoPro S34 Series, Инструкция по эксплуатации

Страница: 22 / 83

Series S34 Instruction Manual Chapter 2 Installation
M-000-00030 2-11
6. With the transducer cables connected, apply a thin coat of coupling grease to the
transducers. If the coupling grease that came with your SonoPro® flow meter
unit runs out, contact VorTek Instruments to order a replacement container.
7. Place the transducers in the left and right mounting bracket of the rail/ fixture
system. Once the rightmost transducer is fitted, move the clamp so that the scribe
line on the transducer is placed at the flow meter’s determined location. Re fer to
the green arrow in Figure 2-11 for this locating point. Tighten the set screw com-
pletely.
8. Tighten the worm-drive clamps using a standard screwdriver so the rail fits tight
on the pipe.
9. Tighten the screw with plastic knob on the top of each transducer mounting
clamp so the transducer fits tight on the pipe. Do not overtighten.
Figure 2-11. Spacing Locating Point on Small Rail/Fixture System*
* Note: Scale not shown here. Scale to be included with actual Small Transducer Rail/Fixture