Vorsis AirAura, Руководство пользователя

Страница: 22 / 65

User Presets
AirAura comes equipped with several dozen factory presets and can hold a total
of 80 presets in its onboard memory. You can design and save additional presets
within AirAura’s onboard memory and can store an unlimited number of presets
on the PC that is hosting the remote control GUI software.
The factory pre-sets can be readjusted and then saved to new names in order to
create a unique and individual sound. Note: The factory presets are write-
protected and changes made to them cannot be written back to the same
memory location. Factory presets whose control settings have been modified are
considered “user” presets and therefore must be saved as a new name and to a
new preset number. Please start with a factory preset that has the on air sound
closest to what you need, and then make any necessary changes to that preset
to get to your final sound.
When changing presets, especially to ones tuned very differently from the current
preset, it may take several seconds for the new settings to become effective. For
instance if a gentle preset is selected after an aggressive preset has been in use
the audio output will be lower at first until the new parameters settle in. Also, to
avoid clicks and pops when presets are changed the preset parameters are
ramped between the current parameter values and the new ones.
When a preset has been recalled and no changes have been made to it, the
preset’s name will show as green text in the GUI. If changes have been made to
the preset, it will be displayed in red text. Once the modified settings have been
saved the preset name will once again appear in green.
NOTE: User presets stored in locations 1 through 8 are logically assigned to the
remote GPI function. Two examples of presets that might be stored here are:
- A preset that has all processing turned off and/or has special input/output level
calibrations (such as for Bypass or EAS purposes).
- A preset that has all processing enabled but has the Stereo Pilot turned off
(Mono Preset).
Preset storage is typically as follows:
- Presets 1 - 8 are user preset storage locations that can be quickly selected by
activating them via the GPI interface and its rear panel connector.
- Factory presets are installed starting at Preset 9, with Preset 9 being a “Bypass”
preset. The factory presets cannot be written over or deleted.
17