Volvo XC 60 TWIN ENGINE, Руководство пользователя

Страница: 426 / 620

||
STARTING AND DRIVING
424
Braking on wet roads
When driving for a prolonged period of time in
heavy rain without braking, the braking effect may
be delayed slightly when next using the brakes.
This may also be the case after a car wash. It is
then necessary to depress the brake pedal more
forcefully. You should therefore maintain a
greater distance to the vehicles in front.
Brake the car firmly after driving on wet roads or
using a car wash. This warms up the brake discs,
enabling them to dry faster and protecting them
against corrosion. Bear in mind the current traffic
situation when braking.
Braking on salted roads
When driving on salted roads, a layer of salt may
form on the brake discs and brake linings. This
may extend braking distance. You should there-
fore maintain a greater safety distance to vehi-
cles in front. In addition, make sure you do the
following:
•
Brake now and again to remove any layer of
salt. Make sure that other road users are not
put at risk by the braking.
•
Gently depress the brake pedal after finish-
ing driving and before starting your next trip.
Maintenance
To keep the car as safe and reliable as possible,
follow the Volvo service intervals as specified in
the Service and Warranty Booklet.
New and replaced brake linings and brake discs
do not provide optimal braking effect until they
have been "worn in" a few hundred kilometres.
Compensate for the reduced braking effect by
depressing the brake pedal harder. Volvo recom-
mends only fitting brake linings that are approved
for your Volvo.
IMPORTANT
The wear on the brake system's components
must be checked regularly.
Contact a workshop for information about the
procedure or engage a workshop to carry out
the inspection - an authorised Volvo work-
shop is recommended.
Symbols in the driver display
Symbol Specification
Check the brake fluid level. If the
level is low, fill with brake fluid and
check for the cause of the brake
fluid loss.
Fault in pedal sensor.
Symbol Specification
Constant glow for 2 seconds when
the engine is started: Automatic
function check.
Constant glow for more than 2
seconds: Fault in the ABS system.
The car's normal brake system is
still working, but without the ABS
function.
If the message
Brake pedal Cha-
racteristics changed Service
required
is shown, the system for
"Brake-by-wire" is disengaged. The
brake pedal engages deeper and a
higher pedal pressure is required
to achieve braking effect.