VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
8.3.19.5 show gvrp portstate
To show gvrp statistics IFNAME status.
CLI Syntax:
show gvrp portstate [IFNAME] VID
Example:
Switch#show gvrp portstate fastethernet1/0/1 1
8.3.20 CoS/QoS
8.3.20.1 queue cos-map
Use the ‘queue cos-map configuration’ command on the switch to select the CoS queue
that a given priority should map into.
CLI Syntax:
queue cos-map PRIORITY QUEUE
Example:
Switch(config)#queue cos-map 1 3
8.3.20.2 show queue cos-map
This command shows the information of CoS and priority mapping.
CLI Syntax:
show queue cos-map
Example:
Switch#show queue cos-map
8.3.20.3 qos mode
This command sets qos mode to high_first mode.
CLI Syntax:
qos mode high_first
Example:
Switch(config)#qos mode high_first
8.3.20.4 show qos mode
This command shows the qos mode.
CLI Syntax:
show qos mode
Example:
Switch#show qos mode
8.3.20.5 qos egress bandwidth
This command is used to set the QoS bandwidth informational parameter for the
outgoing packets.
CLI Syntax:
qos egress bandwidth LIMIT_RATE
Example:
Switch(config)# interface fastethernet1/0/2
Switch(config-if)#qos egress bandwidth 100
95
