VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
Router Reports
Routing Protocol:
the routing protocol type of the route. If it is “connected”, the
destination is on the local LAN segment connected to the interface
Destination:
destination IP address. It will be masked to generate an IP range as the
objective IP addresses of packets to be routed.
Mask:
the mask for generating a range of IP addresses.
Connected via:
IP address of the next router for routing to another network.
Interface:
the interface or VLAN ID from which the packets are routed outside.
7.6 Routing
7.6.1 Static
Route
This function is used to add a routing entry into the switch routing table. The routing
entry added this way will never be deleted by the system, so it is called a static route.
Following parameters must be input to configure static route:
Destination:
Input destination IP address.
Netmask:
Input subnet mask of the destination for generating the IP range to be routed.
Gateway IP:
Input gateway IP address as the next router the packets to be sent to.
Metric:
Input metric (1-15). The lower the metric value is the more preference of the
route.
Click on
Add
when you add a new static route and you will see the new added entry
shows in the list window. You can remove the selected route by clicking
Remove
. The
routes that are added or removed will be stored in the configuration file immediately.
31
