Vivax Metrotech 4.04.000170, Руководство пользователя

Страница: 71 / 76

™
Page 63 of 66
5 The Loc3 Series Transmitters
8. From the main menu, select the “Transmitter Control” option. (that will
become visible when the two devices are linked)
A screen similar to the below should be seen:
Menu
Imperial/Metric
Continuous Information
Auto Power Off
Warnings
Bluetooth Pairing
Transmitter Link
Transmitter Control
Meter
Depth & current
Never
From this screen, if the link status shows “Connected,” it is possible to:
a. Alter the output level of the transmitter using the “+” and “-” buttons.
b. Alter the transmit frequency using the “f” button.
Also shown is the:
Radio link signal strength, in this case, 40%.
Output mode, in this case, direct connection.
Output current, in this case, 100mA.
Beeper volume setting, in this case, level 2.
Transmitter battery level.
Transmitter link status Connected 40%
Transmitter Control
640 Hz
100
mA
Use the Information button to navigate/exit back to the locate screen.
When in the Locate screen, the status of the link is displayed in the Status bar.
4G
The various indications of the status are listed below:
No radio module or it is disabled (Always disable in the User Menu when not in use)
No link and no signal
No link and poor signal
No link but good signal
Is linked to the transmitter but the signal is poor
Is linked to the transmitter with a good signal
TIP
While the Transmitter and Receiver are linked, changing the Receiver Frequency will automatically
result in a similar change to the Transmitter frequency, so there is no need to re-enter the menu
screen to change the Transmitter frequency remotely. The Frequency indicator will flash when
resetting or if an invalid frequency is requested.
If the Tx/Rx Radio link is not being used, make sure the receiver’s link is set to “Disabled” on both RX
and TX. The radio link will continue to search for the transmitter or receiver that may interfere with the
Bluetooth operation. Also, disabling when not in use will conserve battery charge.