Vitris Portavant 80 automatic, Руководство пользователя

Страница: 29 / 38

Portavant 80 automatic 28
Revision 12/2017
10 Troubleshooting
Problem Potential cause Remedial action
Door does not respond, and
display does not light up
when pressing "Menu" No mains power Check mains power; check
circuit breaker, switch it back
on, if required
Mains power cable
disconnected Check connection of mains
power cable and ensure
secure fit
Mains power cable defective Replace mains power cable
Door does not respond,
display is on or lights up
when pushing "Menu";
display shows "Teach-in
mode
– Push to continue"
Door must reperform teach-
in cycle after power failure Push-start the door into
either direction and wait for
teach-in cycle to complete
Door does not respond,
display is on or lights up
when pushing "Menu";
display shows "Please wait" Excessive door use or
excessive ambient
temperatures Please wait and/or reduce
ambient temperature
Door does not respond,
display is on or lights up
when pushing "Menu";
display shows "Push to
continue"
or “Party mode”
Door has been disabled, e.g.
by double collision with an
obstacle or Party mode Push-start the door into
either direction
Door does not respond to
Push&Go signal; display
lights up when pressing
"Menu" but does not show
any message Door is in manual mode Check operating mode in
user menu and change it, if
required (see operating
instructions)
Drive is defective Replace drive
Door does not respond to
radio push button or radio
remote control (batteries in
sender are not discharged) No radio receiver installed Install radio receiver
Radio receiver and sender
are not connected or paired Pair radio receiver and
sender (see installation
instructions of this system as
well as those of sender and
receiver)
Door does not respond to
motion detector No voltage supply (24V) to
motion detectors or no data
connection to control system Check connections (voltage
supply and data line) of
motion detectors at the
terminals of the drive unit;
check lines for damage
In automatic mode: motion
detectors are disabled in the
user menu Enable the motion detectors
in the user menu (see
operating instructions)
In semi-automatic mode: in
this mode, the motion
detectors are disabled by the
control system (safety
concept) Switch door to automatic
mode, if required (see
operating instructions)
Door responds to motion
detectors with delay Detection area of motion
detectors is not optimally
adjusted Optimise orientation of
motion detectors within the
path of pedestrian traffic
(see motion detector
instructions)