Vitris Portavant 80 automatic, Руководство пользователя

Страница: 23 / 38

Portavant 80 automatic 22
Revision 12/2017
the door in Party mode please follow the instructions as set out in Chapter 8.2 (Operating the
door/Party mode).
If the activation of Party mode is experienced as a nuisance (e.g. with different users who
are not familiar with the function), Party mode as such can be deactivated as described
above.
Displaying performed motion cycles:
Press "Menu" again to display the number of motion cycles the system has performed.
Observe the information provided in section 9 "Maintenance". Please state the number of
motion cycles when submitting complaints or contacting service personnel.
Product version:
Press "Menu" again to display the version number of the product. Observe the information
provided in section 10 "Troubleshooting". Please state the product version when submitting
complaints or contacting service personnel.
Verifying the settings:
Press "Menu" repeatedly to verify all settings and change them by using the "+" or "-" key, if
required.
Note: This display switches off automatically after one minute.
Reset:
Use a suitable pin to press in the "Reset" button. Pressing the "Reset" button will reboot the
software. The display will show a request to perform a teach-in cycle ("Teach-in mode
–
Push to continue"). Push the door into either direction. Ensure that the travel path of the door
is free of any obstacles as the subsequent teach-in cycle will determine the end positions.
Use the "Reset" button to repeat the teach-in cycle if it is interfered or interrupted. The
"Reset" button can also be used if the software does no longer respond and if the drive
system does not move the door after push-starting.
Note: Pressing the "Reset" button does not delete the settings made in the menu, i.e. the
default settings are not restored.
8.2 Operating the door
Push&Go function (standard function):
The Push&Go function allows you to push-start the door into either direction. The direction
into which the door is pushed over the push travel set in the user menu is detected by the
control system which then automatically activates the door drive. Let the door go as the drive
cuts in.
DANGER!
(Risk of crushing/shearing/impact)
Keeping hold of the door as the drive system cuts in may cause the door to
stop and reverse its motion (collision detection).
If the door is pushed too quickly and then released, the drive system will
attempt to resume the set motion speed. In case of power failure or in manual
mode, the drive system is not able to control the door speed, and the door
must be moved by hand over its entire travel, slowing it down as it approaches