Transcendent IP Cameras v4: Operation Manual
15
Noise Reduction
: Decrease the noise and make the image more thorough. Increasing the value will
make the noise reduction effect better but it will reduce the image resolution.
Backlight Compensation
:
l
Off: Close the backlight compensation function. It is the default mode.
l
WDR
u
As to the WDR scene, WDR will help the camera provide clear images when there are both very
bright and very dark areas simultaneously in the field of view by lowering the brightness of the bright
area and increasing the brightness of the lowlight area. High, middle and low can be selected.
u
There will be some recording lost for a few seconds during mode changing from non-WDR to
WDR mode.
l
HLC: Lower the brightness of the whole image by suppressing the brightness of the image’s
highlight area and reducing the size of the halo area.
l
BLC: The exposure will begin automatically according to the scene for the goal of seeing the
darkest area of the image.
HFR
:
High frame rate mode. You may enable or disable it as needed.
Antiflicker
:
l
Off: Close the anti-flicker function.
l
50Hz: Makes sure the horizontal stripes will not appear in the image while the device is adjusting
the exposure automatically according to the brightness of the scene when the electric supply is 50Hz.
l
60Hz: Makes sure the horizontal stripes will not appear in the image while the device is adjusting
the exposure automatically according to the brightness of the scene when the electric supply is 60Hz.
White Balance
: Adjust the color temperature according to the environment automatically.
Frequency
: 50Hz and 60Hz (50Hz= PAL(Europe) 60Hz= NTSC (North America)).
Day/night Mode
: Please choose the mode as needed.
Auto= will change to Black & White in low light
Day= Camera will be in color all the time
Night= Camera will be in Black & White all the time
Schedule= set a particular time the camera switches to Night mode or Day mode
Sensitivity
: High, middle and low can be selected.
Infrared Mode
: You may choose “ON”, “OFF” and “Auto” as required.
Exposure Mode
: You may choose “Auto” or “Manual” as required.
Corridor Pattern
: You can change the direction of the video image by using this function. 0, 90, 180
and 270 are available. The default value is 0. The video resolution should be 1080P or under 1080P if
you use this function.
Image Mirror
: Reverse the current video image right and left.
Image Flip
: Turn the current video image upside down.
1.3.2
Video / Audio Configuration
Go to Image
à
Video / Audio interface as shown below. In this interface, you can set the resolution,
frame rate, bitrate type, video quality and so on subject to the actual network condition.