Vitalinq 94A-07, Руководство по эксплуатации и установке

Страница: 35 / 47

29
AS DESK MIC, THE HEADSET MIC WILL BE MUTED.
Doctor can’t hear the Operator.
• Verify that Headset plug is in all the way.
• Try another Headset.
• Unplug the Foot Switch. If the Doctor can hear, then replace Foot Switch.
• Move Headset and Foot Switch to jacks on the other side of Console. (The left and right
sides of the Console are separate Headset channels.)
• On the rear of the Console are small white slotted shaft, which controls Headsets “TALK”
volume. The “TALK” and “LISTEN” volume controls and Foot Switch control the Headset
plugged into the same side of the console.
• Place the ‘TALK-MUTE Switch’ in the up (“TALK”) position. Press the desk mic talk bar.
(This uses the desk microphone and not the Headset.) If the Doctor can now hear the Op-
erator then the problem is that the Headset or Headset circuit of the Console is not working.
If the Doctor still can’t hear, the problem is either in the White Cable, the Console or the
Cath Lab microphone.
5.2 Music troubleshooting guide
The following checklist will help you remedy problems you may encounter with your unit.
General
No sound
• The volume is too low.
• The CD is incompatible with the disc format (MP3/WMA).
• The unit is turned off. Turn unit ON by Pressing (SOURCE).
No beep sound.
The beep sound is canceled (see 4.2.3).
The contents of the memory have been erased.
The power to the unit has been disconnected (unplugged).
During playback or reception, demonstration mode starts.
If no operation is performed for 5 minutes with “DEMO-ON” set, demonstration mode starts.
Set “DEMO-OFF” (see 4.2.1).
The display disappears from/does not appear in the display window.
The dimmer is set “DIM-ON” (see 4.2.3).
The display disappears if you press and hold ( SOURCE/OFF).
Press and hold ( SOURCE/OFF) on the unit until the display appears.
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates after turning off the unit.
Turn off the unit.