Vislink HDT-1000, Руководство пользователя и техническое руководство

Страница: 12 / 62

Page 12
HDT-1000 User and Technical Manual
Web Browser Control Interface
The HDT-1000 has on-board firmware that enables web browser control without the
need to install software. To set-up PC control of your transmitter, complete the following
steps:
1. Connect an Ethernet network cable to the RJ-45 Ethernet connector on the front
panel of the HDT-1000 and to your PC.
2. Open a web browser and type [default address] 192.168.1.200 into the URL
address field and press Enter . A login screen displays.
3. Enter your user name and password then click the Login button.
NOTE : The transmitter is factory programmed with the user name root and
password root. To avoid unauthorized access, the factory assigned password
should be changed by accessing the System > Password Change tab. See
Change Password section.
4. If the password to access the radio has been lost, the radio can be returned to
factory default settings.
WARNING: This will erase all presets, encryption keys, and other setings in
addition to setting the radio back to the default factory login and password.
This reset is done by simultaneously holding down the up, down, and preset keys
for 10 seconds. When the reset is done, the radio will go through its startup cycle,
indiating that the reset has taken place.
root
root
Write down your password information here.
Login
Password
Unit S/N