Vislink DXL5000 RX, Руководство пользователя и техническое руководство

Страница: 16 / 40

2-6 Installing the DXL5000 DXL5000 User and Technical Manual
2.3 Installing the DXL5000
This section describes typical mounting and cabling for the DXL5000.
Your installation may vary. The DXL5000 is typically mounted in a
standard rack. Each unit occupies 1 rack unit (1RU) of height.The
cabling is permanently installed and power comes from the facility or
site power source.
WARNING
Follow instructions carefully. Do not place the
equipment on an unstable support such as a
cart, stand, or table. The equipment could fall
and cause equipment damage or cause
personal injury.
• Position the rack to allow easy access to the front and rear of
the equipment.
• Be sure to allow room behind the equipment rack for the
cables required. Do not press the cables against the rear of
the equipment when closing doors because it stresses the
cables and may shorten their life.
• Do not overload the rack or load it unevenly. Secure the rack
to a solid surface. Make certain that the rack and mounting
rails are strong and rigid enough to support all the equipment
in the rack.
Do the following to set up the components at each receive site.
(Mounting the DXL5000 into an equipment rack is easier if one
person holds the unit while another person installs the mounting
screws.)
1. Line up the mounting holes on the receiver front panel with
the mounting holes on the rack as shown in the following
figure.
2. Install the two bottom screws first. Use lock washers to
prevent loosening. Tighten securely.
3. Install the top two screws. Use lock washers to prevent
loosening. Tighten securely.
Note
For non-US applications, you must replace the 3-prong male connector.
The DXL5000 does not have a power switch but powers up when plugged into a power source.
When you power up the DXL5000, it uses the settings that were used when the unit was
powered down, and automatically resumes transmitting if no major alarm conditions exist.
L
L
L
L
L
L
L
L