Vislink DXL5000 RX, Руководство пользователя и техническое руководство

Страница: 15 / 40

Installing the DXL5000 2-5 DXL5000 User and Technical Manual
2.2.5 Routing Cables
Wiring is affected by temperature, humidity, and vibration extremes. You should do the following
installation.
CAUTION
Power supply cords and cables must be protected. Do not run cords
where they can be stepped on. Protect cables against pinching and
chafing. Pay special attention to locations where the cables enter or exit
an enclosure or make a sharp bend.
• Secure all cables at close intervals along their entire lengths.
• Protect cabling with added sheathing or padding anywhere cabling passes through a
hole or lies against an obstruction.
• Provide flex relief at any location where the cable must change direction sharply, to
maintain a smooth bend and prevent kinking.
• Provide strain relief at each connector to absorb any pulling forces on the cable and
prevent damage to the connector.
• If long lengths of cable are required, you may need a UHF amplifier or gain block.
Contact Vislink for specific cable types and lengths to use in your application. (See Section 1.3,
Getting Support for Your DXL5000 on page 1-6.)
2.2.6 Power Requirements
The DXL5000 has the following power requirements. AC power fuses are located on the rear
panel next to the power outlet.
CAUTION Ensure that the power being supplied matches the power required by
the equipment. You can find power ratings for equipment on a rating
plate, usually on the rear panel. Ensure that the electrical supply is
protected by over-current protection devices as required by the
applicable electrical codes. If necessary, consult a licensed electrician.
Unit Supply Voltage Fuse Rating
Power
Consumption
Transmitter 120 VAC, 50/60 Hz 3.0A, 250V AGC, Slow Blow 130W nominal
240 VAC, 50/60 Hz
Receiver 120 VAC, 50/60 Hz 1.0A, 250V AGC, Slow Blow 50W nominal
240 VAC, 50/60 Hz